MyPin TD4-SNR with PT100 Wiring Diagram
I have measured my temp with a termapen in various spots to confirm. I have done my best to understand the horrible English in the manual, but that really doesn't help. Or do a water test trying this to see if it helps steady out temps.
That has nothing to do with the probe or circulation. I regret not going with an auber pid.
MyPin TD4-SNR with PT100 Wiring Diagram - The main power switch applies power to the controller, but elements can be off when the controller is on. I really think it is pid settings.
Brew on Posted May 5, 2017 The black jumper provides power to the bottom switch when the top switch is turned on. Thanks for the ideas in advance. This 'E-Stop' is effectively the 'Heat' switch in my setup. Joined: 20 Feb 2014 Posts: 40 Location: Wisconsin Posted: Sun May 11, 2014 11:48 pm Post subject: Aha - figured it out. Or do a water test trying this to see if it helps steady out temps. When power is on, the jumper then enables the heat to be turned on. It doesn't take much to warm the mash tun 1°F. During the boil, the power and heat switches are on the cooling is off.