Peugeot 308 Key Fob Replacement

Peugeot's 308 might be catching on a little however it's still eye-catching. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is ongoing or continuous the following tips will aid.

Water Damage

If you accidentally drop your key fob into a puddle or it is soaked while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry, dry bag each time you go outdoors or do things that expose it to excessive amounts water.

You'll also want to make sure that the fob is dry before opening it up and reusing it. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid) it is a indicator that it is submerged.

A wet circuit board can cause the battery to dump its energy or even explode. If you're able to pull your 308 key fob out of the water in which it was stuck in, flip the button side down and shake out as much water as possible before opening the case. After you open it, take off the battery and clean the circuit board with the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system might fail to function include a dead coin battery or receiver module issue signal interference, an electronic chip that is damaged. If none of the above are the reason, you may try resetting the system by disconnecting the battery with 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote start system that lets drivers start their vehicle from some distance, which allows them to warm up or cool down the vehicle prior to entering. This feature is extremely beneficial particularly during the cold winter months. However, it is possible that the remote stop system stops operating due to a range of reasons, including the battery in the coin is dead.

The coin-shaped battery inside the key fob could last between two and four years based on how frequently it is used, the location it was purchased, and how it is used. The use-by date will be displayed on the packaging or marked in the user's manual.

If the key fob is no longer functioning after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If exposed to salty or soapy water, the chip could be damaged and you'll have to replace the key fob completely.

If you're not sure the battery is in good condition you can check its voltage with an instrument set to the vehicle's voltage range and connected to the minus and plus terminals. If the voltage is less than 12-13 volts, then you should replace the battery. Alternately, you could try to reset the on-board computer by disconnecting the 12 volt battery for a few minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. It's that part that sends a signal to the car when your key fob is activated, it also acts as an immobiliser and prevents it from starting unless the correct key is used.

It could be due to several causes, such as water damage or simply aging. If your Peugeot 308 key fob has been exposed dirty tap water, for instance the chip that is located inside is damaged. In this situation, you'll need to remove it and thoroughly clean it using isopropyl or electronic cleaner. When the battery is dry you can attempt to test it again.

If the issue continues to persist then it's a good idea to visit a local Peugeot specialist or locksmith. They'll be able to make use of a diagnostic device to identify the issue and repair it for you.

Losing your Peugeot car keys can be a stressful experience. However, a trained auto locksmith can address the issue in only a few minutes. They can program your vehicle and cut a fresh, functioning key for you. Click here to find a locksmith near you.

A malfunctioning electronic chip

The electronic chip in the Peugeot 308 key fob plays a crucial part in the remote control system. If the chip is damaged, you may have problems starting your car or receive a message saying "anti-theft". If this happens, the only way to fix the issue is to replace the key. Luckily, auto locksmiths who are professionals can complete the task within the shortest period of time.

The chip inside the chip of your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or other reasons. If your Peugeot key fob has been exposed to dirty or soapy water, it must be cleaned right away. You can use a paper towel and isopropyl alcohol for cleaning the electronic component. The battery should then be allowed to completely dry.

Sometimes keys can not function due to radio interference. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects in the vicinity. If https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ encounter this issue it is recommended to visit the Peugeot dealership.

The Peugeot 207/308 Key Fob is very delicate and requires special care. You shouldn't drop it or throw it around. If you lose it, try to find it as soon as you can. You can reset the on-board computer by disconnecting the battery for a few minutes. Be sure to disconnect the negative first, and then the positive.