Peugeot 208 Key Replacement

Peugeot 208 key replacement is best left to professional auto locksmiths who have the right equipment and technical knowledge. They will be able to make and program new keys much faster than a dealership would and at a lower cost.

If your key fob has stopped locking or unlocking your doors it is likely due to a dead battery in the coin. However, there are other reasons the key could be malfunctioning.

Dead Coin Battery

A dead coin battery will stop your Peugeot 208 from locking and unlocking, as well as making it impossible to start the engine. In this instance you'll need to make use of the alternative method for starting as described in your vehicle's owner's manual.

The spark plugs can also be worn out. The spark plugs are responsible for igniting the fuel which starts the engine. They are only able to last for a short time. They will eventually break down in the event that they aren't utilized enough.

Luckily, there's an easy solution for this problem. Examine the voltage of your battery using a multimeter. If it's less than 11.5 Volts, then you need to replace it. It is also necessary to clean the contacts of the battery in the event that it is damaged by corrosion. You can do this by lifting the rubber covers that cover the two terminals on the battery and using a wire brush to remove any corroded parts of the battery. Then, you should connect the cables to the positive and negative poles.

Water Damage

If your 208 does not start and the battery hasn't been replaced, you must look at the spark plugs. You might find that they are simply too dirty and do not spark. The spark plugs can be cleaned in the workshop.

Peugeot automobiles use transponder keys that works with the car's ignition system. This ensures only the correct key is able to turn the engine. If the chip in the Peugeot key is damaged, it will not send the proper signal to the vehicle.

Water damage is a typical cause of this problem. This is most common in colder climates. the vehicle might have been exposed to snow or rain. If https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ is the case, contact a reputable auto locksmith who will have all of the tools and equipment needed to change the key's programming. They'll also have the latest technology and equipment required to create a Peugeot smart key. The process should not take more than 15 minutes.

Faulty battery contacts

Peugeot changed from the carbon-encased transponder chips to a brand new type of chip that uses electronic components within a circuit board. The new system is great when it's new, but the circuit boards wear out over time and stop working properly.

This can stop the immobiliser from working, so your vehicle won't start. If this happens it's a good idea to call a Peugeot specialist or locksmith.

The most frequent issue is when the battery inside the key fob begins to fail. This causes the blade of the key to stop feeding into the lock. A locksmith from your vehicle can replace the battery and cut a new blade for you, this is normally a quick fix.

Faulty Receiver Module

It could be that the receiver module is defective in the event that your Peugeot key fob fails to function after being dropped on the floor, or exposed to a sudden storm or accidentally washed. The receiver is responsible for sending radio frequency signals to the on-board computer that controls the central locking system in your Peugeot vehicle.

The key fob itself has rubber seals which prevent water from getting to the chip inside. Water can damage the chip when exposed to water for long periods of time. Submerging the key fob into sea water at the beach or throwing it into the pool could be particularly damaging due to the high salt content.

If your Peugeot spare key fob isn't working, you'll need to have the module replaced. This can only be done by an Peugeot specialist or an expert auto locksmith. As opposed to other cars, Peugeot keys are protected by an exclusive immobilizer system that requires the correct programming to begin the engine. This is why it is imperative that you should only rely on the Peugeot locksmith to create and program an alternative.

Computer on board is not working properly

The computer on board in your Peugeot is responsible for a number of the systems in your car, from power windows to airbags. The computer on board will display a code when something goes wrong. This code is stored in the system and remains there until the problem is solved. This can often mean that the on-board computers to be replaced.

The most frequent cause for the warning light for airbags to flash is corrosion or loose connections in the sensor. This could be due to wear and tear, age or exposure to moisture and salt. This problem should be taken care of as soon as you can, as an airbag that is not functioning could pose danger in the event of an accident.

If you encounter an error message stating that the card is not found on your Peugeot, the key battery inside the key fob may be dead or weak. This can prevent the key fob from sending a signal that disables the standard immobilizer in your vehicle. Try this by pressing the unlock key on the fob's key and then trying to start your car. If this fails it is because the battery of the key has to be replaced.