How to Replace a Nissan Juke Spare Key
Nissan Juke is a fun and stylish hatchback that has an unusual engine setup. It's noisy, but still fun to drive.
Replace the battery of the key fob of your Nissan Juke every two years, or when it's at a low. It's simple to do at home, however you'll need some tools.
Dead Coin Battery
If your Nissan Juke key fob has stopped working the first thing you need to look at is the coin battery that is inside it. It may be dead and needs to be replaced. This is a simple fix that takes just less than a minute. You can do this by flipping the fob and removing the small latch and release on the back. Replace the battery you have previously installed by making sure it's in the middle of the fob. Place the two halves with care.
The fob should be cleaned if it was exposed to water before you are able to insert an entirely new battery. You can clean the fob with isopropyl electronic cleaner and a paper towel. Then, let it dry completely prior to reinstalling the battery.
To start the car the key fob must also be connected to the car. This can be done according to the instructions in your owner's guide or an OBDII scan. If the key fob hasn't been paired, that is the most likely explanation of why it stopped functioning. A damaged chip in the fob can also cause it to stop working however this is extremely rare. A new receiver module could be needed in this case. If this is the case, it will need to be replaced by an accredited technician.
Water Damage
Key fobs are powered by batteries and the batteries must be replaced every two years or at the point that the car ceases to respond when you press the "start" switch. https://www.g28carkeys.co.uk/nissan-car-key-replacements-near-me/ keep out water, but submerging a key fob in the pool or ocean water could damage the chip's electronic. If this is the situation, you will require a new key from Nissan or an automotive locksmith.
If the key fob is equipped with functioning chips it's possible that the computer has lost connection to it, and this could occur for a variety of reasons. It can be fixed by restarting the car. If the "Key ID error" message continues to appear it is necessary to contact Nissan for assistance.
The three most frequent causes of this issue are dead battery on the key fob as well as a key that is not programmed and a damaged or malfunctioning key fob. The first two issues are simple to fix, while the latter is a bit more difficult to identify and repair immediately, but it can be fixed with a bit of patience. WhoCanFixMyCar lets you compare Nissan Key Replacement prices in your area and then book your repair. It only takes a few minutes and you can review customer reviews from local garages, Nissan car mechanics and dealerships before you decide.
Faulty Chip
The key fob of your Nissan Juke has a special chip that sends a signal to the car every time you turn it. If that chip is faulty, it can cause the key to cease functioning. If this happens, the problem will only be resolved by replacing the key. There are a myriad of reasons your Nissan Juke's key could be damaged, including water damage or a dead coin battery or a malfunctioning receiver module.
If your key fob stops working after a wash or bath, you should check the chip for water damage. Make sure the metal clips that hold it in place are secure and the chip is not exposed to any water. If you see any indications of water damage to the electronic component, you should remove the battery and clean it with isopropyl alcohol or electronic cleaner.
If the chip is not working You'll need to contact your local locksmith or dealer. They will need to know the year as well as the model, make and year of your vehicle to find an alternative. You'll also need to note down the VIN (Vehicle Identification Number) so that the locksmith or dealer is aware of the exact key you own. This will enable them to look up the correct key code, and also ensure that they are cutting the correct one.
Faulty Receiver Module
The key fob transmits a radio signal to your car to perform various functions. It can unlock your trunk when you are rushing to get groceries or start your car by pressing the button on the fob. It can also open your windows and switch on the horn should you accidentally lock your keys in the car.
If the key fob won't function, it could be due a problem in the receiver module. The receiver modules are tuned to detect specific frequencies that match the signals generated by the Nissan key fob. A malfunctioning receiver module can stop your car from responding to the signal transmitted by the key fob of Nissan.
It's always best to have a spare Nissan key fob in case your original key gets lost or breaks. A spare key can be programmed by a locksmith or a dealership to work with your Nissan and save you the hassle of locking your keys inside your car or losing them.
If your Nissan Juke key fob has been exposed to clean water from the tap or rain it is possible to have the issue solved by cleaning it with isopropyl alcohol or an electronic cleaner. If the chip is damaged you'll need to purchase the new keyfob, which can be coded for your vehicle by a dealer or locksmith.