Peugeot 308 Key Fob Replacement
Peugeot's 308 might be getting on a bit however it's still eye-catching. https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ 's not the most luxurious vehicle in its class, but it's a relaxing and civilised drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will aid in solving the issue whether it is constant or intermittent.
Water Damage
If you happen to leave your key fob in a puddle or splash it with water when kayaking, swimming, canoeing, rafting, or canyoning, it's more likely to be damaged by water. Keep your key fob in a dry bag whenever you go outdoors or do activities that could expose it to a lot of water.
It's also essential to make sure that the fob has dried out before you open it to use it again. If you detect any odors from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's submerged.
A wet circuit may cause the battery's charge to be drained or even explode. If you can remove your keyfob 308 out of the water it is best to turn the button side up and shake as much water as you can prior to opening the casing. Once you have opened it, take off the battery and wipe down the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system could be unable to function could be due to an empty coin battery, receiver module issues, signal interference, or a faulty electronic chip. If none of these are the cause, you can try resetting your system by disconnecting the battery with 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start systems that lets drivers start their vehicle from a distance, allowing them to warm up or cool down the vehicle before they get in. This feature is extremely useful especially during the cold winter months. The remote start system may stop working for a variety reasons, such as the dead battery in the coin-battery.
A coin-shaped battery that is in the key fob has a lifespan of between two and four years, depending on how frequently it is utilized and where it was purchased. The date of use is written on the packaging or marked in the user manual.
If the key fob has stopped working after exposure to water that is clean it is recommended to take the battery off, clean the chip using a paper towel and isopropyl alcohol, then dry it completely before replacing it. If exposed to salty or soapy water, the chip might be damaged and you'll require replacing the key fob entirely.
If you're not sure whether the battery is defective, you can check the voltage using an instrument connected to the plus and minus terminals. The voltage should be around 12-13 volts, but if it is lower, the battery must be replaced. Alternatively, you can attempt to reset the onboard computer by disconnecting the 12 volt battery for a few minutes and reconnecting it in reverse order (positive cable first, then negative). The engine should then start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, it's possible that the receiver module has been afflicted with a fault. It's that part that sends an alert to the car when your key fob is activated which also acts as an immobiliser. It also stops it from starting unless the correct key is used.
This could be caused by many factors, including water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, as in, the electronic chip inside the device will be damaged. In this instance you'll have to take the device apart and thoroughly clean it with isopropyl alcohol or an electronic cleaner. When the battery is clean you can attempt to test it again.
If the problem persists then it's a good idea to visit a local Peugeot specialist or locksmith. They can use an instrument for diagnosing to identify the issue and fix it.
It is stressful to lose your Peugeot car key. A certified auto locksmith can solve the problem within minutes. They can program your car and cut a new, working key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The chip inside your Peugeot 308 key fob is an important part of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". In this situation, the only solution is to replace the key. Luckily, professional auto locksmiths are able to provide this service within the shortest period of time.
The chip in your Peugeot 308 key fob can fail due to water damage, sweat dirt, or other causes. If your Peugeot key fob has been exposed soapy or dirty water, it needs to be cleaned right away. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. The battery must then be allowed to dry completely.
Radio interference can cause the key fob's functionality to cease. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. It could be caused by bad conditions or objects within the vicinity of the vehicle. It is recommended to see a Peugeot dealer if you experience this issue.
The Peugeot 207/308 Key Fob is delicate and needs special care. It should not be dropped or throw it around. If you lose it, try to locate it as quickly as possible. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative cable first, and then the positive.