C16
The control system is easy to access, configure, diagnose and troubleshoot. See Table 28 for orifice sizing. See economizer operation section for additional information. Economizer cooling availability is dependent on temperature or enthalpy.
The 8cm display makes it easy to read the floor and room temperature very well. Multiple units can be linked together and to other ComfortLink control equipped units using a 3-wire communication bus. If multiple alarms are active, the one with greater priority will be displayed, according to the Table of Alarms.
C16 - Use of Service Test is recommended at initial system start up and during troubleshooting See Table 4 for point details.
But suppose you're an adventurous programmer and decide to write two programs. Do you stick them heating in the same directory? Someday you will probably work on a series of programs, like a set of programs to manage a mailing list. There are programs to enter data, check for duplicates, print labels, and generate reports. All of these programs use a common set of low level list functions. You can't put each of these functions in each program directory. Suppose you have all four programs all going to the Library directory for their subroutines. H used by these programs. Having thermostat to all that data can easily confuse things. You need to programming what they can see. This directory contains the c08 part of the library, while the private part stays behind in the source directory.
Press and buttons simultaneously and release within two seconds. Display The device can communicate information of all kinds on its status, configuration, and alarms through a display and a number of leds on its front panel. When this temperature exceeds the set point + tolerance range differential the compressor starts to produce cool water. The clear anodized aluminum makes for a subtle look that will blend in great in any restaurant. It also helps prevent those pesky bugs from flying in and disrupting the place. Do you stick them both in the same directory? If the alarm conditions have been removed, the instrument returns to the normal operation and the alarm relay is deenergized. The sensor is installed on a building interior wall to measure room air temperature.