Peugeot 308 Key Fob Replacement

Peugeot's 308 is a little old but it's striking. It's not the plushest car in its class It's a Ford Focus or Volkswagen Golf will protect you from surface imperfections - but it's a relaxed and pleasant drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is constant or intermittent the following suggestions should assist.

Water Damage

When you accidentally leave your fob in a puddle or splash it with water during kayaking, swimming, canoeing, rafting, or canyoning, it's more likely to sustain water damage. Keep your key fob in a dry bag whenever you go outside or engage in things that expose it to a lot of water.

You'll also want to make sure that the fob is completely dry prior to opening it and using it again. If you notice any odors emanating from the fob such as an industrial-type liquid smell or that of windshield washer fluid, this is another indication that it's been submerged in water.

A circuit board that is wet could cause the battery to discharge its energy or even explode. If you can get your keyfob 308 from the water you need to turn the button side up and shake as much water as you can prior to opening the casing. After opening it, take off the battery and clean the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.

Other reasons your Peugeot 308 remote entry keyless system may not work include a dead battery in the coin-cell or receiver module malfunction signal interference, or a defective chip. If none of the above are the problem, you can try resetting the system by disconnection of the battery that is 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start feature that allows the driver to start the car from afar and then warm up or cool down the vehicle prior to stepping inside. This feature is extremely helpful, especially during cold winter months. However, sometimes the remote start system stops operating due to a range of reasons, such as the battery of a coin that is dead.

A coin-shaped battery in the key fob can last for a period of two to four years, depending on how often it is utilized and where it was purchased. The date of use will be written on the packaging or marked in the user manual.

If the key fob has stopped working after being exposed to water that is clean, remove the battery and clean the electronic chip with the aid of a towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If the key fob was exposed to salty or soapy water, it could have caused the chip to be damaged. You'll need to replace it.

If you are not sure the battery is faulty, you can test the voltage with a multimeter set to your car's voltage range, and connect it to the terminals for minus and plus. If the voltage is lower than 12-13 volts it is time to replace the battery. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now begin.

Faulty Receiver Module

If you don't see the "Key Detected" It could be the receiver module not working properly. It's that part that sends an alert to the car when the key fob is activated which also acts as an immobiliser. It stops it from starting until the correct key is present.

It could be due to a number of causes, such as water damage or simply the aging process. If your Peugeot 308 key fob has been exposed to dirty tap water, as in, the electronic chip inside the device will be damaged. In this instance, you'll have to take it off and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try again.

If the issue is not resolved, it is a good idea to visit the local Peugeot expert or locksmith. They can use an instrument for diagnosing to pinpoint the problem and repair it.

It is stressful to lose your Peugeot car key. However, a trained auto locksmith can solve the issue in only a few minutes. They can cut a brand new key and then program it into your vehicle, ensuring that you're off the road as quickly as possible. Click here to find a locksmith near you.

Faulty Electronic Chip

The electronic chip in the Peugeot 308 key fob is an crucial component of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message that says "anti-theft". In https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ , the only solution is to replace the key. Auto locksmiths with experience can provide this fastest possible time.

The chip inside your Peugeot 308 key fob can fail due to sweat, water damage dirt, or any other cause. If your Peugeot 308 key fob is exposed to soapy water, you should take it to the cleaners immediately. You can employ a paper towel as well as isopropyl alcohol to clean the electronic component. The battery should then be allowed to dry completely.

Radio interference can cause a key fob to stop working. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects in the vicinity. It is recommended to see a Peugeot dealer if you have this problem.

The Peugeot key fob 207/308 is extremely delicate and requires a lot of attention. You should not drop it or throw it around. If you lose something, try to find it as quickly as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a short period of time. Remove the negative cable before the positive.