TS-Z10LS4
Can I wire both subs to both amps in parallel to get 300 watts at 2 ohm for each one? Which should put out maybe 7000 Rms?
That baby was awesome, it worked for like 3 weeks before it started developing a burnt taste. However, if you build a dual-coil ie. Edit: Ok, I went back and put some headers in with bold print to break it up.
TS-Z10LS4 - Want to run the front speakers only on mid and treble and have the bass come from the sub... Or does that present a 2ohm load?
Hey Everyone, It has been a while since I posted on the forums. Been away like a champ and wanted to show off a sub ohm coil I built. For this build I decided to try something new I always sub ohm and I have been building my own since my day 1 of. This time around I wanted to try something a little more complex. I wish I did this as a dual coil setup to get the ohms down to about 0. This coil is what is called a twisted chain. In order to build it you need a drill. The general idea is to make 2 twisted wires then reverse twist those 2 wires together to make a chain effect. This increases surface area and increases vapor production but it does have a bit of a ramp up. As always use good batteries especially with chain as the first few pulses till you get it aligned will short. Basically what happens is the coil chains short on themselves until alignment is just right. Now for the wicked pic of this beast. I build this with 26 ga. Sorry pics are not the best used my phone. Flavor is very good off this single coil. The pic of the fire is a bit bland the battery was not a full battery puts out much more fresh. That was my intention and the video I used to learn how to do it love Twisted vids wish he made them more often. I ran into a issue with the coiling probably due to using a super old drill or maybe not enough tension where the wire wanted to wave before it started to triangle. So I stopped and left it at a Twisted Chain V1 he has a video of that as well. I really did not want to have to start all over again. When my nichrome wire comes in I will try my hand at a again. I find the nichrome is actually softer so it tends to cooperate better in these applications. The outer diamater as you said is a big issue with the coil had a tough time getting it away from the top cap in my Dark Horse. Not quite sure I really like this coil it seems to leave lots of room for experimentation.
I will refuse to order anywhere else for 5 main reasons. Just pretend, in the upper diagram, that the two amps share the same chassis and do not need the extra power, ground, or turn-on lead wires. It can do 800w at 4ohms, 1250w at two elements and 1600 at 1ohm. Let's start with that Hifonics ZRX3216. I was only sharing about my journey of why and how I switched over from dual coil to single coil cartomizers. Being that it's much easier to get proper ohms on a single coil, as on most rebuildables, medico builds cut the ohm rating in half. Proper Disposal - DO NOT pour e-liquid down a drain. Back in the stone age of vaping, when power tools were the go to… actually fast forward a bit. These folks have earned my business and I'll be sol my friends that this is the best Vape headquarters for vape products. Improved battery life was the overwhelming reason.