Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a bit however, it's still appealing. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is persistent or intermittent, the following tips should aid.
Water Damage
If you accidentally drop your key fob in a puddle or it is wet while kayaking, canoeing or rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry bag every time you go outdoors or do activities that could expose it to excessive water.
It's also crucial to ensure sure the fob has completely dried before you open it to use it again. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid) This is a further indication that it's been submerged.
A wet circuit could cause the battery's power to be depleted or even explode. If you're able to pull your key fob 308 out of the water body it got stuck in, flip the button side down and shake it out as much water as you can before opening the case. Take the battery out, and then wipe the circuit board down using a cotton swab that has been dipped in 90-percent alcohol.
Other reasons your Peugeot 308 remote entry keyless system may not work include a dead coin cell battery or receiver module issues, signal interference or a malfunctioning chip. If none of the above are the reason, you may try resetting the system by removing the battery at 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to stepping inside. This feature is very useful especially during the cold winter months. However, there are https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ when the remote stop system stops working due to a variety of causes, such as an unresponsive coin battery.
A coin-shaped battery that is located inside the key fob can last for a period of between two and four years, based on how often utilized and where it was purchased. The use-by date will be printed on the packaging or mentioned in the user manual.
If the key fob has stopped working after being exposed to clean tapwater, take out the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then dry the chip completely before replacing. If the key fob has been exposed to soapy or salty water, it could have caused the chip to become damaged. You'll need to replace it.
If you're not sure the battery is faulty, you can test its voltage with a multimeter set to your car's voltage range and connected to the minus and plus terminals. If the voltage is less than 12-13 volts, then you must replace the battery. Alternately, you could try to reset the on-board computer by disconnecting the 12 volt battery for a few minutes, and then reconnecting it in reverse order (positive cable first, then negative). The engine should then start after this.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, then it's possible that the receiver module has discovered a problem. It's the part that sends an alarm to the car when your key fob is activated which acts as an immobiliser, and stops it from starting unless the key that you want to use is present.
The cause could be various reasons, such as water damage or just ageing. If your Peugeot 308 key fob was exposed to dirty tap water, as in the electronic chip inside the device will be damaged. In this case you will need to take it out and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry, you can put the battery back into the battery and try again.
If the issue continues to persist you're probably in need of a idea to visit a local Peugeot specialist or locksmith. They'll use a diagnostic tool to identify the problem and fix it.
It is stressful to lose your Peugeot car key. A qualified auto locksmith can solve the issue in minutes. They can program your car and cut a fresh, working key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays an essential function in the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". If this occurs, the only way to fix the issue is to obtain a new key. Auto locksmiths with experience are able to provide this fastest possible time.
The chip inside the key fob of your Peugeot 308 could be damaged due to various reasons, such as sweat, water damage or dirt. If your Peugeot key fob has been exposed to dirty or soapy water, it needs to be cleaned promptly. You can wipe the electronic component using paper towels soaked with isopropyl Alcohol. The battery must then be allowed to fully dry.
Sometimes keys may be inoperable due to radio interference. This could be caused by other devices operating on the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects around the vehicle. If you experience this problem you should visit a Peugeot dealership.
The Peugeot 207/308 Key Fob is delicate and needs special care. It is imperative not to throw or drop the key fob. If you lose something, try to locate it as soon as you can. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Unplug the negative cable prior to the positive.