Peugeot 308 Key Fob Replacement

Peugeot's 308 might be a bit old but it's still striking. It might not be the most luxurious car in its class and an Ford Focus or Volkswagen Golf will help you stay away from road imperfections, but it's a relaxing and a civilized drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is ongoing or continuous the following suggestions should assist.

Water Damage

If you accidentally drop your key fob in a puddle or it is soaked while kayaking, canoeing, rafting, or canyoning the fob is most likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry bag whenever you're outdoors or performing activities in which the fob may be exposed to excessive amounts of water.

You should also make sure that the fob is dry before opening it up and re-using it. If you notice any odors coming from the fob, like an industrial liquid smell or windshield washer fluid, it's another indication that it's submerged in water.

A wet circuit may cause the battery's charge to drain or even explode. If you can pull your 308 keyfob out of the water you need to turn the button side up and shake as much water out as possible before opening the casing. Remove the battery, then wipe the circuit board clean using a cotton swab that has been dipped in 90-percent alcohol.

Other reasons why your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module malfunction signal interference or a malfunctioning chip. If none of these are the reason you can restart the system by disconnecting the 12 volt battery from your car for 15 mins.

Dead Coin Battery

Peugeot cars come with a remote start system which allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the car prior to entering. This feature is very beneficial especially during the cold winter months. Remote start systems can cease to function for a variety reasons, such as a dead coin-battery.

The coin-shaped battery that is within the key fob may last between two and four years, based on how often it is utilized, the place it was purchased and how it is utilized. The date of use is typically printed on the package or marked in the manual.

If the key fob stopped functioning after exposure to clean tap water and you want to take the battery off, clean the electronic chip with a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. If the key fob has been exposed to soapy or salty water, it may have caused the chip to be damaged. It is necessary to replace it.

If you're unsure if the battery is defective, you can check the voltage using an instrument connected to the minus and plus terminals. If the voltage is lower than 12-13 volts you should replace the battery. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now start.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, then it's possible that the receiver module has discovered a problem. It's the component which sends out an alert when your key fob turns on. It also acts as an alarm and prevents the car from starting if you don't have the correct key.

It could be due to several reasons, such as water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, for example the chip that is located inside is damaged. In this scenario you'll have to take it apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. When the battery is clean then you can try again.

If the issue persists, it is recommended to consult a local Peugeot expert or locksmith. https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ can utilize the diagnostic tool to pinpoint the problem and fix it.

Losing your Peugeot keys to your car is an emotional experience. However, a qualified auto locksmith can solve the issue in a matter of minutes. They can cut a new key and then program it into your vehicle, ensuring that you're ready to get out on the road in the shortest amount of time. Click here to find a locksmith near you.

A malfunctioning electronic chip

The electronic chip inside the Peugeot 308 key fob is a very important component of the remote control system. If the chip is damaged, you may have problems starting your car or get a message saying "anti-theft". If this occurs, the only way to fix the problem is to get a new key. Luckily, auto locksmiths who are professionals can provide the service within the shortest period of time.

The chip in the key fob of your Peugeot 308 could fail due to different reasons, such as sweat, water damage or dirt. If your Peugeot key fob was exposed to soapy or dirty water, it should be cleaned right away. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. After that, you should let the battery completely dry.

Sometimes the key fob may be inoperable due to radio interference. This can be caused by other devices operating at the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects in the vicinity of the vehicle. If you have this issue, it is best to visit an Peugeot dealership.

The Peugeot 207/308 Key Fob is delicate and requires special attention. You shouldn't drop it or throw it around. If you lose something, try to find it as soon as you can. You can reset the on-board computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative first, and then the positive.