Peugeot 308 Key Fob Replacement

Peugeot's 308 might be slightly old but it's eye-catching. It's not the plushest car in its class and a Ford Focus or Volkswagen Golf will shield you from surface imperfections - however, it's a comfortable and civilised driving experience.

We often get asked at Coded Car Keys to replace peugeot key fobs. If the issue is constant or intermittent these tips will assist.

Water Damage

If you accidentally drop your key fob into a puddle or it is wet while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry bag whenever you are outside or perform things that expose it to excessive water.

You should also ensure that the fob is completely dry before opening it up and using it again. If you smell any odors emanating from the fob (such as industrial liquid or windshield washer fluid) it is a indicator that it is submerged.

A wet circuit could cause the battery's charge to drain or even explode. If you're able to fish your 308 key fob out of the water in which it was stuck in turn the button upside down and shake it out as much water as possible before opening the case. After opening it, take out the battery and wipe down the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.

Other reasons your Peugeot 308 remote keyless entry system could fail to function include the battery of your coin is dead, receiver module issues, signal interference, or an electronic chip that is defective. If none of these is the problem, you can try resetting the system by removing the battery at 12 volts for around 15 minutes.

Dead Coin Battery

Peugeot cars come with remote start systems that lets drivers start their vehicle from some distance, which allows them to warm up or cool down the vehicle before entering. This feature is very beneficial especially during the cold winter months. However, sometimes the remote start system ceases working due to a variety of causes, such as the battery in the coin is dead.

The coin-shaped battery within the key fob may last between two and four months, depending on how often it is used, where it was purchased and how it is utilized. The date of use is typically printed on the packaging or marked in the manual.

If the key fob is not functioning after exposure to clean tap water, you should remove the battery, clean the chip using a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If exposed to salty or soapy water, the chip could be damaged and you'll need to replace the key fob altogether.

If you're unsure if that the battery is not working properly it is possible to test the voltage with a multimeter that is set to the car's voltage range and connected to the terminals for minus and plus. If the voltage is less than 12-13 volts then you need to replace the battery. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now start.

Faulty Receiver Module

If you don't get the "Key Detected" It could be the receiver module not working properly. It's the part that sends a signal to the car when the key fob is activated, which acts as an immobiliser and prevents it from starting until the correct key is used.

This could result from a variety of reasons, including water damage or simply aging. If the electronic chip in your Peugeot 308 keyfob is damaged due to dirty tap water it could be due to the fact that the keyfob was exposed to it. In this scenario you'll need to remove off the battery and clean it thoroughly using isopropyl alcohol or an electronic cleaner. When the battery is clean you can try it again.

If the issue isn't resolved you're probably in need of a option to consult a local Peugeot specialist or locksmith. They'll be able to utilize a diagnostic tool to identify the problem and fix it.

The loss of your Peugeot keys to your car can be a stressful experience. A certified auto locksmith will be able to solve the issue in a matter of minutes. They can program your vehicle and cut a new, working key for you. Click here to locate locksmiths near you.

Faulty Electronic Chip

The electronic chip in the Peugeot 308 key fob plays a vital role in the remote control system. If it is damaged, your car might not start or receive a message saying "anti-theft active". In this case the only option is to replace the key. Fortunately, https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ with experience can complete the task within the shortest period of time.

The chip inside the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or other causes. If your Peugeot key fob was exposed to dirty or soapy water, it needs to be cleaned as soon as possible. You can make use of a towel and isopropyl alcohol to wipe the electronic component. After that, you should let the battery completely dry.

Sometimes keys may be inoperable due to radio interference. This could be caused by other devices operating at the same frequency as your Peugeot key fob. This can be caused by unsafe conditions or objects that are in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer in the event of this problem.

The Peugeot key fob 207/308 is extremely delicate and requires a lot of care. It is not recommended to drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset your on-board computer by disconnecting the battery for a few minutes. Disconnect the negative cable prior to the positive.