Peugeot 308 Key Fob Replacement

Peugeot's 308 is a little old, but it is still eye-catching. It might not be the most luxurious car in its class It's the Ford Focus or Volkswagen Golf will shield you from sloping surfaces - but it's a relaxed and pleasant driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is constant or intermittent, the following tips should help.

Water Damage

If you accidentally drop your key fob in a pool or splash it with water when kayaking, swimming, canoeing, rafting or canyoning, it's probably to suffer water damage. Keep your key fob in a dry bag whenever you go outside or engage in things that expose it to excessive water.

You should also ensure that the fob is dry before opening it up and re-using it. If you notice any odors emanating from the fob like an industrial smell or a sour taste like windshield washer fluid, this is another indication that it's been submerged in water.

A wet circuit can cause the battery's charge to be drained or even explode. If you're able to pull your 308 key fob out from the body of water it got stuck in, flip the button side down and shake out as much water as you can before opening the case. After opening it, take off the battery and wipe the circuit board with the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system might not function include an empty coin battery, receiver module issues signal interference, a faulty electronic chip. If none of these is the issue, try resetting your system by disconnecting the 12 volt battery for about 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from a distance, warming up or cooling down the car prior to entering. This feature is extremely helpful, especially during cold winter months. Remote start systems can be stopped for a variety of reasons, such as the dead battery in the coin-battery.

A coin-shaped battery that is in the key fob has a life span of between two and four years, depending on how often it is used and the location where it was purchased. The date of use is usually found on the packaging or marked in the manual.

If the key fob stopped functioning after exposure to clean tap water, you should remove the battery, clean the electronic chip with a paper towel and isopropyl alcohol, then dry it completely before replacing it. In the event of exposure to salty or soapy water, the chip may be damaged and you'll require replacing the key fob entirely.

If you're unsure whether the battery is in good condition it is possible to check its voltage with an instrument connected to the terminals plus and minus. If the voltage is lower than 12-13 volts then you must replace the battery. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now begin.

Faulty Receiver Module

If you don't get the "Key Detected" message, it could mean that your receiver module is defective. It is the part that sends out an alert when your key fob turns on. It also acts as an alarm that stops the car from starting if it doesn't have the correct key.

This could be due to a number of factors including water damage or simply ageing. If the electronic chip within your Peugeot 308 keyfob is damaged due to dirty tap water it could be due to the fact that the keyfob was in contact with it. In https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ is necessary to take off the battery and thoroughly clean it with isopropyl alcohol or an electronic cleaner. Once it's dry, you can put the battery back in and test it again.

If the problem persists it is recommended that you visit a local Peugeot expert or locksmith. They can use the diagnostic tool to pinpoint the problem and then fix it.

Losing your Peugeot car keys could be a stressful experience. However, a qualified auto locksmith can fix the problem in minutes. They can program your vehicle and cut a brand new, functioning key for you. Click here to find a locksmith near you.

Faulty Electronic Chip

The electronic chip inside your Peugeot 308 key fob is a very vital component of the remote control system. If it becomes damaged, your car might not start, or you could receive a message stating "anti-theft active". In this instance the only option is to replace the key. Auto locksmiths who are professionals can provide this fastest possible time.

The chip in the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or other reasons. If your Peugeot key fob has been exposed dirty or soapy water, it should be cleaned right away. You can make use of a paper towel and isopropyl alcohol to clean the electronic component. After that, you should allow the battery to dry completely.

Sometimes keys can be inoperable due to radio interference. This can be caused by other devices that operate at the same frequency as your Peugeot key fob. It could be caused by bad conditions or objects within the vicinity of the vehicle. It is recommended to visit a Peugeot dealer in the event of this issue.

The Peugeot 207/308 key fob is extremely delicate and requires a lot of attention. You should not drop it or throw it around. If you lose something, try to locate it as soon as you are able to. You can reset the onboard computer by disconnection of the battery for a few minutes. Make sure you disconnect the negative cable first, then the positive.