Peugeot 308 Key Fob Replacement

Peugeot's 308 might be getting on a bit however, it's still attractive. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is ongoing or continuous these tips will help.

Water Damage

If you accidentally drop your key fob in the puddle, or it is soaked while kayaking, canoeing, rafting, or canyoning, the fob is likely to be damaged by water. The best method to prevent this from happening is to keep it in a dry, dry bag when you're going outdoors or doing activities in which the fob may be exposed to high levels of water.

It's also essential to make sure the fob has completely dried out before you open the fob and then use it. If you smell any odors emanating from the fob (such as industrial liquid or windshield washer fluid) It's another indication that it's submerged.

A circuit board that's damp can cause the battery to dump its charge or even explode. If you're able fish your key fob 308 out of whatever body of water it was stuck in then flip the button side down and shake it out as much water as you can before opening the case. After you open it, take out the battery and clean the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.

Other causes why your Peugeot 308 remote entry keyless system may not function could be due to a dead coin-cell battery, receiver module problems, signal interference or a defective chip. If https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ of the above is the issue, you can reset the system by removing the 12 voltage battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote start system that allows the driver to start the car from afar, warming up or cooling down the vehicle prior to entering. This feature is extremely beneficial particularly during the winter's cold and chilly months. Remote start systems may stop working for a variety reasons, including a dead coin-battery.

The coin-shaped battery inside the key fob can last between two and four months, depending on the frequency with which it is used, the location it was purchased and how it is utilized. Its use-by date is typically printed on the packaging or in the manual.

If the key fob is no longer working after being exposed to clean tapwater, take out the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing. If you expose it to soapy or salty water, the chip may be damaged and you'll require replacing the key fob altogether.

If you're not sure the battery is in good condition, you can test its voltage using a multimeter set to your car's voltage range, and connect it to the minus and plus terminals. If the voltage is lower than 12-13 volts you need to replace the battery. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should then start after this.

Faulty Receiver Module

If you're not seeing the "Key Detected" message on your dashboard, it's possible that the receiver module has discovered a problem. It's the component that transmits a signal when your key fob activates. It also acts as an alarm and prevents the car from starting without the correct key.

This can be due to many causes, such as water damage or simply aging. If your Peugeot 308 key fob has been exposed to dirty tap water, for example the electronic chip inside may be damaged. In this instance you'll need to remove it apart and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry, you can put the battery back into the battery and try again.

If the issue continues to persist you're probably in need of a idea to see a local Peugeot specialist or locksmith. They'll be able make use of a diagnostic device to assist in identifying the problem and fix it.

The loss of your Peugeot car keys can be a stressful experience. A qualified auto locksmith will be able to resolve the issue within minutes. They can program your vehicle and cut a new working key for you. Click here to find a local locksmith near you.

Faulty Electronic Chip

The electronic chip in the Peugeot 308 key fob is an important part of the remote control system. If it is damaged your car might not start, or you could receive a message saying "anti-theft active". In this case, the only solution is to replace the key. Luckily, professional auto locksmiths can offer the service within the shortest period of time.

The chip inside the key fob of your Peugeot 308 may become faulty for many reasons, such as water damage, sweat or dirt. If your Peugeot key fob has been exposed to dirty or soapy water, it needs to be cleaned immediately. You can employ a paper towel as well as isopropyl ethanol to clean the electronic component. The battery must then be allowed to completely dry.

Radio interference can cause the key fob to stop working. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. This can be caused by problems with the environment or objects in the vicinity of the vehicle. If you have this issue you should visit the Peugeot dealership.

The Peugeot 207/308 key fob is extremely delicate and requires attention. You should not drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Unplug the negative cable prior to the positive.