Peugeot 308 Key Fob Replacement
Peugeot's 308 may be a little old, but it is still appealing. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. These tips can aid whether the issue is constant or intermittent.
Water Damage
If you happen to leave your key fob in a pool or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's more likely to sustain water damage. Keep your key fob in a dry bag every time you go outside or engage in things that expose it to excessive amounts water.
It's also crucial to ensure sure the fob has completely dried out prior to opening it to use it again. If you detect any smells coming from the fob, like an industrial smell or a sour taste like windshield washer fluid, it's another indication that it's submerged in water.
A wet circuit could cause the battery's power to be depleted or even explode. If you can remove your keyfob 308 from the water and turn it upside up and shake as much water out as you can before opening the casing. After you open it, take off the battery and clean the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system may not work include a dead coin cell battery or receiver module issues signal interference or a faulty chip. If none of these are the issue you can reset the system by disconnecting the 12 voltage battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start systems which allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the vehicle before entering. This feature is extremely beneficial particularly during the winter's cold and chilly months. However, it is possible that the remote start system ceases working due to a variety of reasons, including a dead coin battery.
The coin-shaped battery located within the key fob may last between two and four years based on how often it is used, where it was purchased, and how it is utilized. The date for use-by is typically written on the package or in the manual.
If the key fob stops working after exposure to clean tapwater, take out the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then, dry the chip thoroughly before replacing. If the key fob was exposed to salty or soapy water, it could have caused the chip to become damaged. It is recommended to replace it.
If you're not sure if the battery is defective, you can check its voltage using a multimeter attached to both the plus and minus terminals. If the voltage is less than 12-13 volts, it is time to replace the battery. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should begin to run after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, then it's possible that your receiver module has developed a fault. It's that part that sends an indication to the car when your key fob is activated it also acts as an immobiliser, and stops it from starting unless the correct key is in place.
The cause could be many causes, such as water damage or just the aging process. If the electronic chip in your Peugeot 308 keyfob is damaged due to dirty tap water It could be because the keyfob was exposed it. In this case you'll have to take the device apart and thoroughly clean it with isopropyl alcohol or electronic cleaner. When the battery is clean then you can try again.
If the issue isn't resolved then it's a good idea to seek out an area Peugeot specialist or locksmith. They'll make use of a diagnostic device to assist in identifying the problem and repair it for you.
Losing your Peugeot car keys could be an extremely stressful experience. However, a trained auto locksmith can resolve the problem in minutes. They can cut a new key and programme it to your vehicle, ensuring you're back on the road again in the shortest amount of time. Click here to find a local locksmith near you.
Faulty Electronic Chip
The electronic chip inside the Peugeot 308 key fob plays a vital role in the remote control system. If it is damaged, your car may not start, or you could receive a message saying "anti-theft active". In this scenario the only option is to replace the key. Auto locksmiths with experience are able to provide the service in the shortest time.
The chip in your Peugeot 308's key fob may fail due to different reasons, such as water damage, sweat or dirt. If your Peugeot 308 key fob is exposed to soapy water, you must cleanse it immediately. You can make use of a towel and isopropyl alcohol to clean the electronic component. The battery should be allowed to fully dry.
Radio interference can cause the key fob to stop functioning. This can be caused by other devices operating at the same frequency as your Peugeot key fob. https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/ could also be caused by bad weather or objects in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer if you experience this issue.
The Peugeot 207/308 Key Fob is fragile and requires special attention. It is crucial not to drop or throw the key fob. If you lose something, try to find it as soon as you are able to. You can reset all the on-board computers by disconnecting the 12 volt battery for a short period of time. Be sure to disconnect the negative cable first, then the positive.